Would you rather upgrade (2) Anycubic Vyper (new hotend, extruder, etc) or buy a new printer?

  • IMALlama@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    21 days ago

    I replied to another post with a list of mods, so take a look at the other comments in the post for some out of box mods.

    As a 350 owner, be aware of two things.

    First, big bed = big chamber = heat soak takes a while and you have a lot more surface area to lose heat from. If you want to print big ABS/ASA parts you’re going to want ACM panels, a better sealed/insulated front door, and potentially a radiant layer inside the printer.

    Second, the big printer limits your rate of acceleration some compared to a smaller CoreXY. IMO if you have a big printer to print big things you’re probably not going to have small/finely detailed parts that often. Those are the kinds of parts that will go a touch slower. But honestly 5k acceleration is orders of magnitude faster than most bed slingers can achieve and 10-15k is only a 2-3x increase so you’re not giving up that much.

    Other than than, no regrets about the 350.

    • mickeyripple@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 day ago

      So I was looking on West3D and found the kit I wanted, but they are out of stock. They also did not have it in 350x350. I’m guessing the only other option is to purchase everything individually rather than a kit.