Basic blender went bad (motor ran but spindle wasn’t rotating). I wanted to disassemble to see if it could be repaired. Three of the four screws were Phillips head. I had to cut the casing open in order to discover why I couldn’t unscrew the fourth. It was a slotted spanner.
So you use the dremel to cut a groove into your screwdriver instead.
👆
Where’d you get such a big brain
Edit - ah, since you can’t see the screw until you cut away at the product, the company is still going to frustrate even the crafty DIYers
make a print with a bit of putty on a stick ?
Great idea! Much more reasonable than trying to get a fiberoptic kind of camera down there.
Damn, I didn’t even think of that. It would be ruining a good screwdriver, but you could just use an old worn flat-head drill bit.
Good call, either way.
At that point, just buy the correct bit for the job.