I am hoping someone may have the ability to scan the front and top of a utility gas meter that looks like the one above.

I would like the use this scan to model a front cover similar to the one shown in this link below, but suited for this type of meter.

https://www.thingiverse.com/thing:4845512

The purpose of this project is to hold a esp32 board to get consistent meter readings and feed them into home assistant. Here is the project below.

https://github.com/jomjol/AI-on-the-edge-device

Any help would be appreciated.

  • @rambos@lemm.eeEnglish
    2•7 months ago

    Afaik scanning will require extra tuning steps. Alternatively you can take rough measurements of few cross sections, then print them on paper, cut the contours and check how it fits, make adjustments and repeat until you are satisfied